Footprint 465 123014 4-Piece Beech Handle Wood Chisel Set 1/4-Inch, 1/2-Inch, 3/4-Inch, 1-Inch

Footprint 465 123014 4-Piece Beech Handle Wood Chisel Set 1/4-Inch, 1/2-Inch, 3/4-Inch, 1-Inch

Average Customer Rating: Recommend

Traditional Beech handles with brass ferules; High quality Sheffield England steel; 4.5" blade tempered to Rockwell 60-61 over entire length; Complete with chisel tip guards; Finish honed ready for use

Product details and pricing info

3 Customer Reviews Posted


Junk
The chisels I recieved were the worst looking tools I have seen in a while. The brass rings were rusting, and they didn't seem to line up right with the handle. The handles looked like they had been rushed through production, there were rough edges that needed sanding and the stamped name was smeared. The business end of the chisels looked awful, I only took out one chisel for inspection and that one had a small chip in the cutting edge. To top it all off, the packaging was for a set of plastic-handled chisels. It is obvious to me that whoever makes these chisels doesn't care at all about their product, so back to Amazon this one goes -- thanks for wasting my time Footprint. I went out to Lowes and got myself a set of stanleys that aren't great but they are a whole lot better than these, and cheaper too.
2007-11-12, 2 of 3 people found this review helpful, Rated:
quality
Made very well, I used them to cut dovetails in curly maple with no problems. They held their edge well. Also these are made in England not in China like the Irwin Marples.
2007-07-04, 1 of 1 people found this review helpful, Rated:
Great tools at a fair price
Just cut a bunch of half blind dovetails in cherry with these. They were easy to sharpen (backs were nice and flat) and stayed sharp. Wood handles are a little square so they don't roll away and they really took a beating. They're also comfortable to hold. Blades are thin enough to fit into the corners of the dovetails. I first ordered the set but had to switch to getting them one at a time when the set was out of stock. Would somebody please ask them to make one in 1/8 inch?
2006-05-16, 3 of 3 people found this review helpful, Rated: